Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1419    Acceleration Sensor Internal Circuit

DTC    C1435    Yaw Rate Sensor Internal Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate and deceleration sensor has a built-in deceleration sensor and detects the vehicle condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate and deceleration sensor) and U0124 (malfunction in CAN communication with the deceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.

DTC Code
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the acceleration sensor.
Yaw rate and deceleration sensor
C1435
A data malfunction signal is received from the yaw rate and deceleration sensor.
Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 .

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform calibration (Click here).

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.REPLACE YAW RATE AND DECELERATION SENSOR
  1. Replace the yaw rate and deceleration sensor (Click here).


NEXT

END