Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Speed Signal Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the vehicle speed signal from the combination meter.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E130075E57


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    1. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to "ON-VEHICLE INSPECTION" in the meter/gauge system (Click here).
    2. The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.INSPECT COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    E160749E03
  1. Disconnect the E80 clearance warning ECU connector.

  1. Jack up the drive wheels.

  1. Move the shift lever to N.

  1. Turn the ignition switch to ON.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Reference 
    Terminal Connections
    E80-3 (SPD) - Body ground
    Tester Range
    5 V/DIV., 20 msec./ DIV.
    Vehicle Condition
    Drive vehicle at 20 km/h (12 mph)
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU)

    HINT:
    As the vehicle speed increases, the wavelength shortens.

    OK:
    Voltage pulses as shown in the illustration

  1. Reconnect the clearance warning ECU connector.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER ASSEMBLY)
  1. Disconnect the E80 clearance warning ECU connector.

  1. Disconnect the E13 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E80-3 (SPD) - E13-14 (+S)
    Always
    Below 1 Ω
    E80-3 (SPD) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)