Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    CB-13    USB Over Current Detection

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
CB-13
USB device or "iPod" overcurrent malfunction
  1. USB device or "iPod"
  2. No. 1 stereo jack adapter assembly
  3. Wire harness or connector
  4. Multi-media interface ECU

WIRING DIAGRAM


E219786E02


INSPECTION PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

4.INSPECT MULTI-MEDIA INTERFACE ECU
  1. Disconnect the E87 No. 1 stereo jack adapter assembly connector.



    E194160E12
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E87-1 (UPI) - E87-4 (UJSG)
    Always
    5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

5.CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the E88 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E87-1 (UPI) - E88-1 (UPO)
    Always
    Below 1 Ω
    E87-4 (UJSG) - E88-4 (UESG)
    Always
    Below 1 Ω
    E87-1 (UPI) - Body ground
    Always
    10 kΩ or higher
    E87-4 (UJSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)