EXHAUST PIPE (for Super Long Wheelbase) > INSTALLATION |
| 1. INSTALL EXHAUST PIPE ASSEMBLY TAIL |
| 2. INSTALL EXHAUST PIPE ASSEMBLY CENTER |
Install a new gasket to the exhaust pipe assembly center.
Connect the exhaust pipe assembly center to the exhaust pipe supports.
Install the exhaust pipe assembly center and exhaust pipe assembly tail with the 2 bolts.
| 3. INSTALL EXHAUST PIPE ASSEMBLY FRONT |
w/ Secondary air infection system:
Install the air fuel ratio sensor. (Click here)
For Unleaded gasoline engine:
Install the oxygen sensor. (Click here)
Inspect the compression spring.
![]() |
Using vernier calipers, measure the free length of the compression springs.
![]() |
Install the gasket.
Fully insert a new gasket to the exhaust manifold by hand.
Using a wooden block, uniformly strike the gasket so that the gasket and exhaust manifold are properly fit.
Install a new gasket to the exhaust pipe assembly front.
Connect the exhaust pipe assembly front to the exhaust pipe support.
Install the exhaust pipe assembly front with the 4 bolts, 2 nuts, and 2 compression springs.
For Unleaded gasoline engine:
Connect the sensor connector(s).
| 4. CHECK FOR EXHAUST GAS LEAKS |