ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the Intelligent Tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Power train / ECT / Data List".
Follow the instructions on the tester and read the Data List.
| Item | Measurement Item/ Range (display) | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light SW Status/ ON or OFF |
| - |
| Neutral Position SW Signal | PNP SW Status/ ON or OFF | Shift lever position is; P and N: ON Except P and N: OFF | When the shift lever position displayed on the Intelligent tester differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
|
| Shift SW Status (L Range) | PNP SW Status/ ON or OFF | Shift lever position is; L: ON Except L: OFF | ↑ |
| Shift SW Status (2 Range) | PNP SW Status/ ON or OFF | Shift lever position is; 2 and L: ON Except 2: OFF | ↑ |
| Shift SW Status (3 Range) | PNP SW Status/ ON or OFF | Shift lever position is; 3: ON Except 3: OFF | ↑ |
| Shift SW Status (R Range) | PNP SW Status/ ON or OFF | Shift lever position is; R: ON Except R: OFF | ↑ |
| Shift Status | Actual Gear position/ 1st, 2nd, 3rd or 4th (O/D) | Shift lever position is;
| - |
| Lock Up Solenoid Status | Lock Up Solenoid Status/ ON or OFF |
| - |
| SLT Solenoid Status | Shift Solenoid SLT Status/ ON or OFF |
| - |
| A/T Oil Temperature 3 | ATF Temp. Sensor Value/ min.: -40°C (-40°F) max.: 215°C (419°F) |
| If the value is "-40°C (-40°F)" or "215°C (419°F)", ATF temp. sensor No.1 circuit is open or shorted. |
| SPD (SP2) | Output shaft Speed/ min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph)
| - |
| SPD (NCO) | Input Turbine Speed/ display: 50 r/min |
| - |
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the Intelligent Tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Power train / ECT / Active Test".
Follow the instructions on the tester and read the Active Test.
| Item | Test Details | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate the shift solenoid valve and set each shift position by yourself. [Vehicle Condition] Less than 50 km/h (31 mph) [Others]
| Possible to check the operation of the shift solenoid valves. |
| Control the Lock Up | [Test Details] Control the shift solenoid SL to set the automatic transmission to the lock-up condition. [Vehicle Condition]
| Possible to check the SL operation. |
| Control the Line Pressure Up * | [Test Details] Operate the shift solenoid SLT and raise the line pressure. [Vehicle Condition]
| - |