P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU)
Diagnostic trouble codes · Vehicles built from Dec 2017
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Dec 2017
DESCRIPTION
Refer to the system description for DTC P2757 (Click here).| DTC No. |
DTC Detection Condition |
Trouble Area |
| P2759 |
Open or short is detected in shift solenoid valve SLU circuit for 1 second or more while driving (1 trip detection logic). |
|
MONITOR DESCRIPTION
When an open or short in a shift solenoid valve SLU circuit is detected, the ECM determines there is a malfunction. The ECM will illuminate the MIL and store this DTC.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Perform registration and/or initialization when parts related to the automatic transmission are replaced (Click here).
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLU) |
Disconnect the transmission wire connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
21 (SLU+) - 22 (SLU-)
20°C (68°F)
5.0 to 5.6 Ω
21 (SLU+) - Body ground
Always
10 kΩ or higher
22 (SLU-) - Body ground
Always
10 kΩ or higher
Text in Illustration *a
Component without harness connected
(Transmission Wire)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
Disconnect the ECM connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
D116-13 (SLU+) - D116-12 (SLU-)
20°C (68°F)
5.0 to 5.6 Ω
D116-13 (SLU+) - Body ground
Always
10 kΩ or higher
D116-12 (SLU-) - Body ground
Always
10 kΩ or higher
Text in Illustration *a
Front view of wire harness connector
(to ECM)
|
|
||||
| OK | ||
| ||
| 3. INSPECT SHIFT SOLENOID VALVE SLU |
Remove shift solenoid valve SLU (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
5.0 to 5.6 Ω
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
- OK:
Measurement Condition
Specified Condition
- Battery positive (+) with a 21 W bulb → Terminal 1
- Battery negative (-) → Terminal 2
Valve moves and makes an operating noise
- Battery positive (+) with a 21 W bulb → Terminal 1
| *1 |
Shift Solenoid Valve SLU |
|
|
||||
| OK | ||
| ||
