C1225 SM Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Dec 2017
Also covers:
- C1468 SFR Solenoid Circuit
- C1469 SFL Solenoid Circuit
- C146A SRR Solenoid Circuit
- C146B SRL Solenoid Circuit
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and they control the pressure acting on the wheel cylinders to control the braking force.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1225 |
Either of the following is detected:
|
Brake actuator assembly |
| C1468 C1469 C146A C146B |
Either of the following is detected:
|
Brake actuator assembly |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. RECONFIRM DTC |
- HINT:
- These codes are detected when a problem is determined in the skid control ECU (brake actuator assembly).
- The solenoid circuits are in the skid control ECU (brake actuator assembly).
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTCs are output before replacing the skid control ECU (brake actuator assembly).
- These codes are detected when a problem is determined in the skid control ECU (brake actuator assembly).
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTCs C1225, C1468, C1469, C146A and C146B are not output
A
DTCs C1225, C1468, C1469, C146A and/or C146B are output
B
- HINT:
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU (brake actuator assembly), with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
- If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the skid control ECU (brake actuator assembly). Make sure that no DTCs are output.
- If any DTCs are output while jiggling a connector or wire harness from the skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness.
- The DTCs were probably output due to a bad connection of the connector terminal.
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU (brake actuator assembly), with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
|
|
||||
| A | ||
| ||
