Slip Indicator Light Remains ON
Circuit diagnosis · Vehicles built from Dec 2017
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.The slip indicator light blinks during VSC and/or TRC operation.
If a malfunction is detected, the slip indicator light comes on to warn the driver (Click here).
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK CAN COMMUNICATION LINE |
|
|
||||
| A | |
| 2. CHECK BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED |
|
|
||||
| OK | |
| 3. INSPECT BATTERY |
|
|
||||
| OK | |
| 4. CHECK TERMINAL VOLTAGE (IG1 TERMINAL) |
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) |
|
|
||||
| OK | |
| 6. READ VALUE USING GTS (SLIP INDICATOR LIGHT) |
Reconnect the B92 skid control ECU (brake actuator assembly) connector.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Slip Indicator Light
Slip indicator light / ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
Check the GTS display condition of the slip indicator light.
- Result:
Result
Proceed to
Display of the Data List remains OFF
A
Display of the Data List remains ON
B
|
|
||||
| A | ||
| ||
