INSTALLATION
Removal / installation · Vehicles built from Dec 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
- HINT:
- Other than areas where instructions are provided, use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Other than areas where instructions are provided, use the same procedure for the RH and LH sides.
| 1. INSTALL FRONT SPEED SENSOR |
Install the front speed sensor to the steering knuckle with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Prevent foreign matter from attaching to the sensor tip.
- When installing the clamps, do not twist the wire harness.
- Prevent foreign matter from attaching to the sensor tip.
Install the bracket to the steering knuckle with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- When installing the clamps, do not twist the wire harness.
Install the bracket to the upper arm with the bolt.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
for LH side:

Attach the 2 wire harness clamps to the body.
Connect the connector.
for RH side:

Install the bracket to the body with the bolt.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Connect the connector.
| 2. INSTALL FRONT WHEEL |
- Torque:
- 100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }
| 3. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (RH POSITION) |
| 4. INSTALL FRONT DOOR SCUFF PLATE RH (RH POSITION) |
| 5. INSTALL FRONT SEAT ASSEMBLY RH (RH POSITION) |
Connect the front seat inner belt assembly connector and install the front seat assembly.

Align the front seat assembly adjuster pin with the holes in the body.
Move the front seat assembly to the rearmost position.
- NOTICE:
- Make sure that the front seat assembly is securely locked.
Temporarily tighten the 2 bolts on the front side of the front seat assembly.
Move the front seat assembly fully forward.
- NOTICE:
- Make sure that the front seat assembly is securely locked.
Temporarily tighten the 2 bolts on the rear side of the front seat assembly.
Move the front seat assembly to the rearmost position.
- NOTICE:
- Make sure that the front seat assembly is securely locked.
Fully tighten the 2 bolts on the front side of the front seat assembly in the order of outer and inner side.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
Move the front seat assembly fully forward.
- NOTICE:
- Make sure that the front seat assembly is securely locked.
Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of outer and inner side.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
| 6. CHECK SPEED SENSOR SIGNAL |
- w/ VSC:
- (Click here)
- w/o VSC:
- (Click here)
