2014-2019 Hiace · Service Manual SECURITIES

B279C Theft Deterrent System Presence Detection

Diagnostic trouble codes · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
An ECM that is incompatible with the immobiliser system is installed (1 trip detection logic*1).
ECM
Check for DTCs.
  1. *1: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-
Related Data List and Active Test 
DTC Code
Data List and Active Test
B279C
-

INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start (CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

    OK:
    DTC B279C is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. REPLACE CURRENT ECM WITH PROPER ECM
  1. Replace the current ECM with the proper ECM (Click here).


NEXT

END


← B279C Theft Deterrent System Presence Detection (Jan 2017 – Nov 2017)Security Indicator Light Does not Blink (Oct 2014 – Mar 2016) →