3.
REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.
4.
REMOVE FAN AND GENERATOR V BELT
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.
NOTICE:
When removing the fan and generator V belt, do not use the bolt of the idle pulley.
HINT:
After removing the fan and generator V belt, move the tensioner upward to the maximum amount.
5.
REMOVE TENSIONER PULLEY
NOTICE:
Perform the following procedure when it is necessary to replace the tensioner pulley.