REMOVAL
Removal / installation · Vehicles built Oct 2014 – Dec 2016
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1.
REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission) |
 |
(Click here)
| 2.
REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) |
 |
(Click here)
| 3.
REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
|
 |
- Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.
Loosen each set bolt one turn at a time until spring tension is released.
Remove the set bolts, and pull off the clutch cover assembly.
- NOTICE:
- Do not drop the clutch disc assembly.
| 4.
REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
|
 |
- NOTICE:
- Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.
| 5.
REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
|
 |
- Fix the crankshaft with SST.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 10 bolts and flywheel.
| 6.
REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
|
 |
- Fix the crankshaft with SST.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 10 bolts, spacer RR, drive plate and spacer FR.
| 7.
REMOVE ENGINE REAR OIL SEAL |
 |
- Using a knife, cut through the oil seal lip.
Using a screwdriver with its tip taped, pry out the oil seal.
- NOTICE:
- After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.