2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2016 from Jan 2017


1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
(Click here)

2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here)

3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

  1. C114267E01
    Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the set bolts, and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.


4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.


5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A102137E01
    Fix the crankshaft with SST.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A109815E02
    Remove the 10 bolts and flywheel.


6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. A102137E01
    Fix the crankshaft with SST.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A102156E01
    Remove the 10 bolts, spacer RR, drive plate and spacer FR.


7. REMOVE ENGINE REAR OIL SEAL

  1. A102142E02
    Using a knife, cut through the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← REMOVAL (Oct 2014 – Dec 2016)INSTALLATION (Oct 2014 – Dec 2016) →