2014-2019 Hiace · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Oct 2014


1. INSPECT BACK DOOR

  1. Check that the clearance of areas A to P are within the standard range.

    B106854E01

    Standard:
    Area
    Measurement
    Area
    Measurement
    A
    21.4 mm (0.843 in.)
    I
    21.5 mm (0.847in.)
    B
    5.2 mm (0.205 in.)
    J
    5.2mm (0.205in.)
    C
    10.1 mm (0.398 in.)
    K
    10.4 mm (0.409in.)
    D
    110.9 mm (4.366 in.)
    L
    111 mm (4.37in.)
    E
    20 mm (0.787 in.)
    M
    18 mm (0.709in.)
    F
    5.2 mm (0.205 in.)
    N
    5.2 mm (0.205in.)
    G
    10.2 mm (0.402 in.)
    O
    10.4 mm (0.409in.)
    H
    110.9 mm (4.366in.)
    P
    111 mm (4.37in.)


2. ADJUST BACK DOOR
  1. Disconnect the cable from negative (-) battery terminal from the battery.

    CAUTION:
    Work must be started at least 90 seconds after the ignition switch is turned off and the negative(-) terminal cable is disconnected from the battery. (The SRS is equipped with a back-up power source. If work is started within 90 seconds of disconnecting the cable from the negative (-) battery terminal and turning the ignitionswitch off, the SRS may deploy.)

  1. B101143
    Loosen the bolts to adjust the back door upper up and down, side to side.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. When adjusting the back door rear side to side, and the back door lock striker assembly, loosen the bolts until the striker can move. Lightly tap the striker with a brass bar for adjustment.

    B106858E01

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. After completing fitting adjustment, confirm the position of the back door side female stopper and back door side male stopper.

    B106857E01

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }

  1. Connect the negative (-) terminal cable to the battery.

  1. Initialize both systems.

  1. Inspect the SRS warning light.

← INSPECTION (from Oct 2014)REASSEMBLY (Oct 2014 – Nov 2015) →