INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
| 1. INSTALL STARTER ASSEMBLY |
for Automatic Transmission:
Install the starter with the bolt and 2 nuts.
- Torque:
- 68 N*m{ 693 kgf*cm , 50 ft.*lbf }
for Manual Transmission:
Install the starter with the bolt and nut.
- Torque:
- 68 N*m{ 693 kgf*cm , 50 ft.*lbf }
Connect the wire harness to terminal 30 with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Close the terminal cap.
Connect the terminal 50 connector to the starter.
for Wide Body:
Install the ground cable with the bolt.- Torque:
- 25 N*m{ 250 kgf*cm , 18 ft.*lbf }
| 2. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for Automatic Transmission) |
Install the No. 1 transmission control cable bracket onto the automatic transmission housing with the 2 bolts.

- Torque:
- 28 N*m{ 286 kgf*cm , 21 ft.*lbf }
| 3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Automatic Transmission) |
Secure the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

Install the transmission control cable assembly onto the control shaft lever with the nut.
- Torque:
- 15 N*m{ 150 kgf*cm , 11 ft.*lbf }
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
