2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL FUEL SENDER GAUGE ASSEMBLY
  1. Install the fuel hose grommet to the fuel tank assembly.

  1. Install a new fuel suction tube set gasket, fuel pump gauge retainer and fuel sender gauge assembly with the 8 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the fuel tank wire, fuel evaporation No.1 tube sub-assembly, fuel tank main tube sub-assembly and fuel tank return tube sub-assembly to the fuel sender gauge assembly.


2. INSTALL FUEL TANK ASSEMBLY

  1. A102475E01
    Using the transmission jack, install the 2 fuel tank band sub-assemblies and fuel tank assembly with the 6 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }

  1. Connect the parking brake cable No.3 with the blot.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }


3. CONNECT FUEL HOSE NO.3

  1. A102472E01
    Connect the fuel hose No.3, and tighten the clamp bolt.


4. INSTALL FUEL HOSE PROTECTOR

  1. A309405
    Install the fuel hose protector to the fuel tank to filler pipe hose and attach the 2 claws.


5. CONNECT FUEL TANK BREATHER TUBE

  1. A102474E01
    Connect the fuel tank breather tube and install the clip.


6. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A114059E01
    Connect the fuel tank main tube sub-assembly and install the clip.


7. CONNECT FUEL TANK RETURN TUBE SUB-ASSEMBLY
  1. Connect the fuel return tube sub-assembly (Click here).


8. CONNECT FUEL TANK WIRE

  1. A114058
    Connect the fuel tank wire.


9. INSTALL PROPELLER SHAFT ASSEMBLY

HINT:
  1. Propeller shaft assembly for Super Long Wheelbase (Click here).
  2. Propeller shaft assembly for Long Wheelbase (Click here).


10. CHECK FOR FUEL LEAKS
  1. Check that there are no fuel leaks anywhere on the fuel system after doing maintenance.

    HINT:
    When checking for fuel leaks, make sure that there is pressure in the fuel line.

← REMOVAL (from Oct 2014)INSPECTION (from Oct 2014) →