REPLACEMENT
Removal / installation · Vehicles built from Jan 2015
| 1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
| 2. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
Using SST, remove the automatic transmission extension housing oil seal.

- SST
- 09308-00010
| 3. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
Coat the lip of a new automatic transmission extension housing oil seal with MP grease.
Using SST and a hammer, drive in the automatic transmission extension housing oil seal.

- SST
- 09309-37010
- Standard depth:
- 5.4 to 5.8 mm (0.213 to 0.228 in.)
- NOTICE:
- Keep the lip free of foreign matter.
- Do not tap the automatic transmission extension housing oil seal at an angle.
- Keep the lip free of foreign matter.
| 4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
