INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Jan 2015 – Dec 2016 from Jan 2017
| 1. INSTALL TRANSMISSION CASE GASKET |
Install 2 new transmission case gaskets to the automatic transmission case sub-assembly.
| 2. INSTALL MANUAL VALVE |
Coat the manual valve with ATF and install it to the transmission valve body assembly.
| 3. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Insert the manual valve lever sub-assembly into the groove on the end of the manual valve and install the transmission valve body assembly to the automatic transmission case sub-assembly with the 12 bolts.

- Torque:
- 11 N*m{ 112 kgf*cm , 8 ft.*lbf }
Text in Illustration *1
Manual Valve Lever Sub-assembly
*2
Manual Valve
- HINT:
- Bolt length:
- Bolt A: 25 mm (0.984 in.)
- Bolt A: 36 mm (1.42 in.)
- Bolt A: 50 mm (1.97 in.)
- Bolt A: 25 mm (0.984 in.)
Install the detent spring and detent spring cover to the transmission valve body assembly with the bolt.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 4. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF, and install it to the valve body oil strainer assembly.
Install the valve body oil strainer assembly to the transmission valve body assembly with the 3 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 5. CONNECT TRANSMISSION WIRE |
| 6. CHECK AUTOMATIC TRANSMISSION SYSTEM |
- for 1TR-FE: (Click here)
- for 2TR-FE: (Click here)
- for 1GD-FTV: (Click here)
