2014-2019 Hiace · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT BRAKE DRUM INSIDE DIAMETER

  1. F006408
    Using a brake drum gauge or equivalent, measure the inside diameter of the drum.

    Standard inside diameter:
    Item
    Specified Condition
    for 254 mm drum:
    254 mm (10.000 in.)
    for 295 mm drum:
    295 mm (11.614 in.)

    Maximum inside diameter:
    Item
    Specified Condition
    for 254 mm drum:
    256 mm (10.079 in.)
    for 295 mm drum:
    297 mm (11.692 in.)

    HINT:
    If the inside diameter of the brake drum is more than the maximum, replace the brake drum.


INSPECT BRAKE SHOES LINING THICKNESS

  1. F042690
    Using a ruler, measure the thickness of the shoe lining.

    Standard thickness:
    Item
    Specified Condition
    for 254 mm drum:
    5.1 mm (0.201 in.)
    for 295 mm drum:
    6.0 mm (0.236 in.)

    Minimum thickness:
    1.0 mm (0.0394 in.)

    HINT:
    If the lining thickness is less than the minimum thickness, or if there is severe, uneven wear, replace the brake shoe.


INSPECT BRAKE DRUM AND BRAKE SHOE LINING FOR PROPER CONTACT

  1. R001564
    Apply chalk to the inside surface of the drum, then grind drum on the brake shoe lining to fit.

    HINT:
    If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.


INSPECT BRAKE WHEEL CYLINDER
  1. Check the cylinder bore and the piston for rust or scoring.

    HINT:
    If necessary, replace the wheel brake cylinder assembly.

← REMOVAL (from Jan 2015)INSTALLATION (Oct 2014 – Dec 2014) →