2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT FRONT UPPER SUSPENSION ARM

  1. C102003
    As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

    Standard:
    Turn the nut smoothly without any play.

    If the value is not within the specified range, replace the front suspension upper arm with a new one.

  1. Check the dust boots for cracks or grease leakage.
    If the value is not within the specified range, replace the front suspension upper arm with a new one.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →