2014-2019 Hiace · Service Manual ENGINE

P0340 Camshaft Position Sensor Circuit

Diagnostic trouble codes · Vehicles built from Oct 2014

DESCRIPTION

The crankshaft position sensor in the engine control system contains a signal plate and a pickup coil for the TDC signal. The TDC signal plate has 1 tooth on its outer circumference. The TDC signal sensor generates 1 signal for every engine revolution. The ECM detects the top dead center by the TDC signals.
DTC No.
DTC Detection Condition
Trouble Area
P0340
No TDC signal to ECM at 400 rpm or more.
  1. Open or short in crankshaft position sensor circuit
  2. Crankshaft position sensor
  3. ECM

WIRING DIAGRAM

A311405E04

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. INSPECT CRANKSHAFT POSITION SENSOR

  1. A105091E01
    Check the crankshaft position sensor installation.

  1. Disconnect the crankshaft position sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    19 to 32 Ω
    1 - 2
    Hot
    24 to 37 Ω

    HINT:
    "Cold" and "Hot" in the following sentence express the temperature of the sensor itself. "Cold" is from -10°C (14°F) to 50°C (122°F) and "Hot" is from 50°C (122°F) to 100°C (212°F).



NG
REPLACE CRANKSHAFT POSITION SENSOR (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ECM - CRANKSHAFT POSITION SENSOR)
  1. Disconnect the crankshaft position sensor connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D62-1 - D100-103 (TDC+)
    Always
    Below 1 Ω
    D62-2 - D100-126 (TDC-)
    Always
    Below 1 Ω
    D62-1 or D100-103 (TDC+) - Body ground
    Always
    10 kΩ or higher
    D62-2 or D100-126 (TDC-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P0335 Crankshaft Position Sensor "A" Circuit (from Oct 2014)P0500 Vehicle Speed Sensor (Oct 2014 – Dec 2014) →