2014-2019 Hiace · Service Manual ENGINE

P0335 Crankshaft Position Sensor "A" Circuit

Diagnostic trouble codes · Vehicles built from Oct 2014

DESCRIPTION

The engine speed sensor in the engine control system contains a signal plate and a pickup coil for the NE signal. The NE signal plate has 56 teeth and is mounted in the injection or supply pump assembly. The NE signal sensor generates 56 signals for every 2 engine revolutions. The ECM detects the engine speed and the cam lift position of the injection or supply pump assembly. The ECM uses the TDC and NE signals for injection timing control. The NE signal is also used for injection volume control.
DTC No.
DTC Detection Condition
Trouble Area
P0335
No NE signal to ECM for 0.5 seconds or more at 680 rpm or more.
  1. Open or short in engine speed sensor circuit
  2. Injection or supply pump assembly
  3. ECM
No NE signal to ECM for 2.0 seconds or more during cranking.

WIRING DIAGRAM

A311405E04

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. INSPECT ENGINE SPEED SENSOR

  1. A105092E03
    Check the engine speed sensor installation.

  1. Disconnect the engine speed sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    205 to 255 Ω

    HINT:
    The engine speed sensor is integrated with the injection or supply pump assembly. If the engine speed sensor is replaced, the injection or supply pump assembly must be replaced in whole.



NG
REPLACE INJECTION OR SUPPLY PUMP ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ECM - ENGINE SPEED SENSOR)
  1. Disconnect the engine speed sensor connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D18-2 - D100-102 (NE+)
    Always
    Below 1 Ω
    D18-1 - D100-125 (NE-)
    Always
    Below 1 Ω
    D18-2 or D100-102 (NE+) - Body ground
    Always
    10 kΩ or higher
    D18-1 or D100-125 (NE-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P0180 Fuel Temperature Sensor "A" Circuit (from Jan 2015)P0340 Camshaft Position Sensor Circuit (from Oct 2014) →