Measure the resistance from the DLC3 before checking the CAN bus wires to troubleshoot the CAN communication system.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
CAUTION:
For vehicles with an airbag system:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
NEXT
2. CHECK FOR OPEN CIRCUIT IN DLC3 BRANCH WIRE AND V1 BUS CIRCUIT CAN MAIN WIRE AND SHORT CIRCUIT (CANH - CANL)
Measure the resistance according to the value(s) in the table below.