Driver Side Door UNLOCK Detection Switch Circuit
Circuit diagnosis · Vehicles built Jan 2015 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
The door lock position switch is built in the front door lock assembly.This switch turns on when the door lock knob is in the unlock position and turns off when it is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR LOCK POSITION SWITCH) |
Remove the front door lock assembly (Click here).
Inspect the front door lock assembly (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY [BODY ECU] - FRONT DOOR LOCK ASSEMBLY AND BODY GROUND) |
Disconnect the H7 instrument panel junction block assembly (body ECU) connector.
Disconnect the L1*1 or K1*2 front door lock assembly connector.
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- for LHD :
Tester Connection
Condition
Specified Condition
H7-4 (LSWD) - L1-7 (LSSR)
Always
Below 1 Ω
L1-8 (E) - Body ground
Always
Below 1 Ω
H7-4 (LSWD) or L1-7 (LSSR) - Body ground
Always
10 kΩ or higher
- for RHD :
Tester Connection
Condition
Specified Condition
H7-4 (LSWD) - K1-7 (LSSR)
Always
Below 1 Ω
K1-8 (E) - Body ground
Always
Below 1 Ω
H7-4 (LSWD) or K1-7 (LSSR) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
