TERMINALS OF ECU
System information · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
| TERMINALS OF ECU |


| Symbols (Terminal No.) |
Terminal Description |
| +BS (1) |
Power supply for solenoid |
| GND1 (2) |
Skid control ECU ground |
| P (6)* |
P shift position switch signal |
| FL- (8) |
Front left wheel speed sensor output |
| FL+ (9) |
Front left wheel speed sensor input |
| STP (10) |
Stop light switch input |
| RL+ (11) |
Rear left wheel speed sensor input |
| RL- (12) |
Rear left wheel speed sensor output |
| WA (13) |
ABS warning light output |
| D/G (14) |
Diagnosis tester communication line |
| TS (15) |
Sensor check switch input |
| TC (16) |
Diagnosis switch input |
| PKB (18) |
Parking brake switch input |
| N (20)* |
N shift position switch signal |
| +BM (23) |
Power supply for motor |
| GND2 (24) |
Skid control ECU ground |
| IG1 (25) |
ECU power supply |
| FR- (30) |
Front right wheel speed sensor output |
| FR+ (31) |
Front right wheel speed sensor input |
| RR+ (33) |
Rear right wheel speed sensor input |
| RR- (34) |
Rear right wheel speed sensor output |
- *: for Automatic Transmission
| TERMINAL INSPECTION |
Disconnect the connector and measure the voltage or resistance on the wire harness side.


- HINT:
- Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
+BS (B19-1) - Body ground
W-R - Body ground
Power supply for solenoid (Front battery)
Always
10 to 14 V
GND1 (B19-2) - Body ground
W-B - Body ground
Skid control ECU ground
Always
Below 1 Ω
STP (B19-10) - Body ground
G - Body ground
Stop light switch input
Stop light switch ON → OFF (Brake pedal depressed → released)
8 to 16 V → Below 1.5 V
PKB (B19-18) - Body ground
B - Body ground
Parking brake switch input
Ignition switch ON, parking brake switch ON → OFF
Below 1.5 V → 10 to 14 V
+BM (B19-23) - Body ground
W - Body ground
Power supply for motor (Front battery)
Always
10 to 14 V
GND2 (B19-24) - Body ground
W-B - Body ground
Skid control ECU ground
Always
Below 1 Ω
IG1 (B19-25) - Body ground
B - Body ground
ECU power supply
Ignition switch off → ON
Below 1 V → 10 to 14 V