PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.
- NOTICE:
- When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.
- HINT:
- Inspect the fuse and relay before investigating the suspected areas as shown in the table below. Inspect each malfunction circuit in numerical order for the corresponding symptom.
| Symptom |
Suspected Area |
See page |
| ABS does not operate |
Check the DTC again and make sure that the normal system code is output. |
Click here
|
| IG power source circuit |
Click here
|
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Check the brake actuator with the intelligent tester. If abnormal, check the hydraulic circuit for leakage. |
- |
|
| Front skid control rotor |
Click here
|
|
| Rear skid control rotor |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly. |
Click here
|
|
| ABS does not operate efficiently |
Check the DTC again and make sure that the normal system code is output. |
Click here
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| Check the brake actuator with intelligent tester. If abnormal, check that hydraulic circuit for leakage. |
- |
|
| Front skid control rotor |
Click here
|
|
| Rear skid control rotor |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly. |
Click here
|
|
| ABS warning light abnormal (Remains on) |
ABS warning light circuit |
Click here
|
| Brake actuator assembly |
Click here
|
|
| ABS warning light abnormal (Does not come on) |
ABS warning light circuit |
Click here
|
| Brake actuator assembly |
Click here
|
|
| ABS sensor DTC check cannot be done |
Check the DTC again and make sure that the normal system code is output. |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly. |
Click here
|
|
| Test mode (Signal check) cannot be done |
TS and CG terminal circuit |
Click here
|
| Brake actuator assembly |
Click here
|