2014-2019 Hiace · Service Manual BRAKE

TERMINALS OF ECU

System information · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


TERMINALS OF ECU
C111164E06
Text in Illustration 
*a
Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))
-
-
Terminal No. (Symbol)
Terminal Description
1 (+BS)
Power supply for solenoid
2 (GND)
Skid control ECU ground
5 (CANL)
CAN communication line L
6 (CANH)
CAN communication line H
8 (FL-)
Front left wheel speed sensor output
9 (FL+)
Front left wheel speed sensor input
10 (STP)
Stop light switch input
11 (RL+)
Rear left wheel speed sensor input
12 (RL-)
Rear left wheel speed sensor output
15 (TS)
Sensor check switch input
16 (TC)
Diagnosis switch input
18 (PKB)
Parking brake switch input
20 (N)*
N shift position switch signal
22 (P)*
P shift position switch signal
23 (+BM)
Power supply for motor
24 (GND)
Skid control ECU ground
25 (IG1)
ECU power supply
26 (SP1)
Speed signal output for speedometer
30 (FR-)
Front right wheel speed sensor output
31 (FR+)
Front right wheel speed sensor input
33 (RR+)
Rear right wheel speed sensor input
34 (RR-)
Rear right wheel speed sensor output
  1. *: for Automatic Transmission

TERMINAL INSPECTION

  1. Disconnect the B19 connector and measure the voltage or resistance on the wire harness side.
    C111153E03

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU (Brake Actuator Assembly))
    -
    -

    HINT:
    Voltage cannot be measured with the connector connected to the skid control (brake actuator assembly) as the connector is watertight.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    B19-1 (+BS) - Body ground
    W-R - Body ground
    Power supply for solenoid (Front battery)
    Always
    11 to 14 V
    B19-2 (GND) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    B19-10 (STP) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch on → off (Brake pedal depressed → released)
    8 to 14 V → Below 1.5 V
    B19-18 (PKB) - Body ground
    B - Body ground
    Parking brake switch input
    Ignition switch ON, parking brake switch on → off
    Below 1 V → 11 to 14 V
    B19-23 (+BM) - Body ground
    W - Body ground
    Power supply for motor (Front battery)
    Always
    11 to 14 V
    B19-24 (GND) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    B19-25 (IG1) - Body ground
    B - Body ground
    ECU power supply
    Ignition switch off → ON
    Below 1 V → 11 to 14 V
    B19-26 (SP1) - Body ground
    P - Body ground
    Speed signal output for speedometer
    Ignition switch ON
    11 to 14 V

← TERMINALS OF ECU (Oct 2014 – Dec 2014)DIAGNOSIS SYSTEM (Oct 2014 – Dec 2014) →