2014-2019 Hiace · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015

DESCRIPTION

The Malfunction Indicator Lamp (MIL) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually. When the ignition switch is first turned ON, the MIL should be illuminated and should then turn off after the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.

WIRING DIAGRAM

A280176E08

INSPECTION PROCEDURE


1. CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.

    Result 
    Result
    Condition
    Proceed to
    ON → OFF
    Ignition switch ON → engine is started
    A
    MIL does not illuminate
    Engine does not start
    B
    MIL remains ON
    -
    C



B
GO TO VC OUTPUT CIRCUIT (Click here)

C
Go to step 2
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)

2. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: System Select / Health Check.

  1. Check the DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    Any DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A


3. PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test / Check Engine Indicator.

  1. Check the status of the MIL while performing the Active Test.

    Result 
    Result
    Proceed to
    Changes
    A
    Does not change
    B



B
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE ECM (Click here)


← Brake Override System (from Jan 2015)MIL Circuit (from Jan 2015) →