2014-2019 Hiace · Service Manual ENGINE

VC Output Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the manifold absolute pressure sensor and accelerator pedal position sensor.

WIRING DIAGRAM

A311415E03

INSPECTION PROCEDURE


1. CHECK MIL
  1. Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.

    Result 
    Condition
    Proceed to
    MIL does not illuminate
    A
    MIL illuminates
    B



B
SYSTEM OK
A


2. CHECK CONNECTION BETWEEN GTS AND ECM
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and GTS on.

  1. Check the communication between the GTS and ECM.

    Result:
    Condition
    Proceed to
    Communication is not possible
    A
    Communication is possible
    B



B
GO TO MIL CIRCUIT (Click here)
A


3. CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR)
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Turn the ignition switch to ON.

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL does not illuminate
    A
    MIL illuminates
    B



B
REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR
A


4. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR)
  1. Disconnect the accelerator pedal position sensor connector.

  1. Turn the ignition switch to ON.

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL does not illuminate
    A
    MIL illuminates
    B



B
REPLACE ACCELERATOR PEDAL ROD ASSEMBLY (Click here)
A


5. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the accelerator pedal position sensor connector.

  1. Disconnect the ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D100-96 (VCPM) - Body ground
    Always
    10 kΩ or higher
    B74-58 (VCPA) - Body ground
    Always
    10 kΩ or higher
    B74-57 (VCP2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← ECM Power Source Circuit (from Oct 2014)Starter Signal Circuit (from Oct 2014) →