2014-2019 Hiace · Service Manual ENGINE

Air Conditioning Signal Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

When the A/C compressor is on, the air conditioning amplifier sends the A/C signal to the ECM, and the ECM increases the fuel injection volume to improve driveability during engine idling.

WIRING DIAGRAM

A311408E05

INSPECTION PROCEDURE


1. READ VALUE USING GTS (A/C SIGNAL)
  1. Connect the GTS to the DLC3.

  1. Start the engine.

  1. Turn the air conditioning switch on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / A/C Signal.

  1. Read the value.

    Result:
    A/C Compressor
    Display
    OFF
    A/C Signal OFF
    ON
    A/C Signal ON



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the air conditioning amplifier assembly connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H19-8 (AC1) - B74-47 (AC1)
    Always
    Below 1 Ω
    H19-8 (AC1) or B74-47 (AC1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY (CHECK VOLTAGE)

  1. A311409E01
    Start the engine.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Connection
    Specified Condition
    H19-8 (AC1) - Body ground
    A/C compressor ON
    1.3 to 2.6 V
    H19-8 (AC1) - Body ground
    A/C compressor OFF
    3.7 to 4.5 V

    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Amplifier Assembly)



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE ECM (Click here)


← Starter Signal Circuit (from Oct 2014)Air Conditioning Cut Control Circuit (from Oct 2014) →