2014-2019 Hiace · Service Manual ENGINE

Air Conditioning Cut Control Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

This circuit cuts air conditioning operation during vehicle acceleration in order to increase acceleration performance. During acceleration with the vehicle speed at 30 km/h (19 mph) or less and accelerator pedal opening angle at 45° or more, the A/C magnetic switch is turned off for several seconds.
The air conditioning is also controlled by the ECM outputting the engine coolant temperature to the air conditioning amplifier asembly.

WIRING DIAGRAM

A311408E06

INSPECTION PROCEDURE


1. READ VALUE USING GTS (CHECK OPERATION AIR CONDITIONER CUT CONTROL)
  1. Connect the GTS to the DLC3.

  1. Start the engine and turn the air conditioning switch on.

    HINT:
    A/C magnetic clutch is turned on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the A/C cut signal and read its value displayed on the GTS.

  1. Check operation of A/C magnetic clutch cut when air conditioning cut control is operated by the GTS.

    OK:
    A/C magnet clutch is turned OFF.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the air conditioning amplifier assembly connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H19-10 (ACT) - B74-15 (ACT)
    Always
    Below 1 Ω
    H19-10 (ACT) or B74-15 (ACT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY (CHECK VOLTAGE)

  1. A311409E02
    Start the engine.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H19-10 (ACT) - Body ground
    A/C compressor ON
    10 to 14 V
    H19-10 (ACT) - Body ground
    A/C compressor OFF
    Below 1.0 V

    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Amplifier Assembly)



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE ECM (Click here)


← Air Conditioning Signal Circuit (from Oct 2014)Brake Override System (Oct 2014 – Dec 2014) →