DTC No.
|
DTC Detection Condition
|
Trouble Area
|
U0073
|
Either of the following is detected:
- A bus OFF state occurs once or more within 0.1 seconds, 10 times in succession. (Sent signals cannot be received.)
- When the +BS terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate sensor and steering angle sensor continues for 1 second or more.
- When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession within 60 seconds.
- The condition that a delay in receiving data from the yaw rate sensor and steering angle sensor occurs more than once within 5 seconds.
|
CAN communication system
|
U0100
|
When the +BS terminal voltage is between 10 and 17.4 V, and the vehicle speed is 15 km/h (9 mph) or more, data cannot be received from the ECM for 2 seconds or more.
|
- CAN communication system
- Skid control ECU (Brake actuator assembly)
- ECM
|
U0124
|
Either of the following is detected:
- When the +BS terminal voltage is between 10 and 17.4 V, and the vehicle speed is 7 km/h or more, data from the acceleration sensor cannot be received for 1 second or more.
- When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession within 60 seconds.
- The condition that data from the acceleration sensor cannot be received occurs once or more within 5 seconds.
|
- CAN communication system
- Skid control ECU (Brake actuator assembly)
- Acceleration sensor (Airbag sensor assembly)
|
U0126
|
Either of the following is detected:
- When the +BS terminal voltage is between 10 and 17.4 V, data from the steering angle sensor cannot be received for 1 second or more.
- When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.
|
- CAN communication system
- Skid control ECU (Brake actuator assembly)
- Steering angle sensor (Spiral with sensor cable sub-assembly)
|