2014-2019 Hiace · Service Manual BODY ELECTRICAL

Back Door Lock Motor Circuit

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

DESCRIPTION

The instrument panel junction block assembly (body ECU) receives the back door lock/unlock request signal from the door control switch or door key cylinder. The instrument panel junction block assembly (body ECU) actives the door lock motor on back door remote control assembly

WIRING DIAGRAM

E292510E03

INSPECTION PROCEDURE


1. INSPECT BACK DOOR REMOTE CONTROL ASSEMBLY
  1. Remove the back door remote control assembly (Click here)

  1. Inspect the back door remote control assembly (Click here).



NG
REPLACE BACK DOOR REMOTE CONTROL ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY [BODY ECU] - BACK DOOR REMOTE CONTROL ASSEMBLY)
  1. Disconnect the 13A instrument panel junction block assembly (body ECU) connector.

  1. Disconnect the a3 back door remote control assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    13A-10 (ACT+) - a3-2
    Always
    Below 1 Ω
    13A-29 (ACT-) - a3-1
    Always
    Below 1 Ω
    13A-10 (ACT+) or a3-2 - Body ground
    Always
    10 kΩ or higher
    13A-29 (ACT-) or a3-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Slide Door Lock Motor RH Circuit (from Jan 2017)Back Door Lock Motor Circuit (Jan 2015 – Dec 2016) →