INSTALLATION
Removal / installation · Vehicles built Oct 2014 – Dec 2014
| 1. INSTALL ATF TEMPERATURE SENSOR |
Coat the O-ring of the ATF temperature sensor with ATF.
Using a 19 mm union nut wrench, install the ATF temperature sensor.
- Torque:
- 15 N*m{ 150 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).
Connect the connector.
| 2. CHECK AUTOMATIC TRANSMISSION FLUID LEVEL |
