INSTALLATION
Removal / installation · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
| 1.
INSTALL NO. 2 ECM BRACKET |
 |
Install the No. 2 ECM bracket with the 2 screws.
-
Torque:
- 3.0 N*m{
31 kgf*cm
, 27 in.*lbf
}
| 2.
INSTALL NO. 1 ECM BRACKET |
 |
Install the No. 1 ECM bracket with the 3 screws.
-
Torque:
- 3.0 N*m{
31 kgf*cm
, 27 in.*lbf
}
| 3.
INSTALL ECM |
 |
- Install the ECM, connect the 2 ECM connectors and lower the 2 levers.
- NOTICE:
- When connecting a ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.
- Make sure that the 2 levers are securely lowered.
Attach the 2 wire harness clamps to the No. 1 ECM bracket and No. 2 ECM bracket.
Install the 3 bolts to the ECM.
-
Torque:
- 5.5 N*m{
56 kgf*cm
, 49 in.*lbf
}
- NOTICE:
- Do not use an ECM that has been dropped or subjected to a strong impact.
Return the floor carpet to its original position.
| 4.
INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
 |
Perform the same procedure as above on the opposite side (Click here).
| 5.
INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
 |
Perform the same procedure as above on the opposite side (Click here).
| 6.
INSTALL FRONT DOOR SCUFF PLATE RH |
|
| 7.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 8.
INSTALL BATTERY SERVICE HOLE COVER (w/ Sub-battery) |
|
| 9.
PERFORM INITIALIZATION |
 |
(Click here)
| 10.
REGISTER ID CODE |
 |
(Click here)
| 11.
CHECK ID CODE |
 |
(Click here)
| 12.
INITIALIZE THE LEARNING VALUE OF THE SUPPLY PUMP ASSEMBLY |
 |
Perform initialization procedures (Click here).
- NOTICE:
- Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.