2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL ECM

  1. A314042
    Install the ECM, connect the 2 ECM connectors and lower the 2 levers.

    NOTICE:
    1. When connecting a ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.
    2. Make sure that the 2 levers are securely lowered.

  1. Attach the 2 wire harness clamps to the No. 1 ECM bracket and No. 2 ECM bracket.

  1. Install the 3 bolts to the ECM.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    NOTICE:
    Do not use an ECM that has been dropped or subjected to a strong impact.

  1. Return the floor carpet to its original position.


4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side (Click here).


5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side (Click here).


6. INSTALL FRONT DOOR SCUFF PLATE RH

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. INSTALL BATTERY SERVICE HOLE COVER (w/ Sub-battery)

9. PERFORM INITIALIZATION
(Click here)

10. REGISTER ID CODE
(Click here)

11. CHECK ID CODE
(Click here)

12. INITIALIZE THE LEARNING VALUE OF THE SUPPLY PUMP ASSEMBLY
  1. Perform initialization procedures (Click here).

    NOTICE:
    Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.

← INSTALLATION (Apr 2016 – Dec 2016)COMPONENTS (from Oct 2014) →