2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the engine coolant in a container and dispose of it according to the local regulations.

  1. Loosen the radiator drain cock plug and drain the engine coolant.

    A340634E01

    Text in Illustration 
    *1
    Radiator Reservoir Cap Sub-assembly
    *2
    Radiator Reservoir Assembly
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Water Drain Cock Plug
    *5
    2-Way
    -
    -

  1. Remove the radiator reservoir cap sub-assembly.

  1. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.


4. REMOVE THROTTLE BODY ASSEMBLY
(Click here)

5. REMOVE FUEL INJECTOR ASSEMBLY
(Click here)

6. REMOVE INTAKE MANIFOLD
  1. Disconnect the vacuum switching valve connector.

  1. Slide the clamp and disconnect the purge line hose from the vacuum switching valve.

  1. A110725
    Detach the 2 wire harness clamps from the wire harness bracket.

  1. Slide the clamp and disconnect the No. 3 PCV hose from the intake manifold.

  1. Slide the clamp and disconnect the vacuum hose from the intake manifold.

  1. A110726
    Remove the bolt and wire harness bracket from the intake manifold.

  1. A337855
    Remove the 5 bolts, 2 nuts and intake manifold.

  1. Remove the gasket from the intake manifold.

  1. Remove the intake manifold insulator from the intake manifold.


7. REMOVE KNOCK CONTROL SENSOR

  1. G037712E01
    Disconnect the knock control sensor connector.

  1. Remove the bolt and knock control sensor.

← REMOVAL (Apr 2016 – Dec 2016)INSPECTION (from Oct 2014) →