2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the engine coolant in a container and dispose of it according to local regulations.

  1. Loosen the radiator drain cock plug and drain the engine coolant.

    A340635E01

    Text in Illustration 
    *A
    w/ Dual VVT-i
    *B
    w/o Dual VVT-i
    *1
    Radiator Reservoir Cap Sub-assembly
    *2
    Radiator Reservoir Assembly
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Water Drain Cock Plug
    *5
    2-Way
    -
    -

  1. Remove the radiator reservoir cap sub-assembly.

  1. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.


3. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


4. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


5. REMOVE FRONT DOOR SCUFF PLATE RH

6. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.


7. REMOVE INTAKE AIR CONNECTOR

  1. A102437
    Slide the clamp and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

  1. Disconnect the vacuum hose from the intake air connector.

  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts and intake air connector.


8. REMOVE THROTTLE BODY ASSEMBLY

  1. A337883E01
    Disconnect the throttle motor connector.
    Text in Illustration 
    *A
    w/ Dual VVT-i
    *B
    w/o Dual VVT-i

  1. Slide the clamp and disconnect the water by-pass hose from the throttle body assembly.

  1. Slide the clamp and disconnect the No. 2 water by-pass hose from the throttle body assembly.

  1. Remove the 4 bolts and throttle body assembly.

  1. A239457
    Remove the gasket from the intake manifold.

← REMOVAL (Apr 2016 – Dec 2016)INSTALLATION (Oct 2014 – Dec 2014) →