2014-2019 Hiace · Service Manual BODY ELECTRICAL

Turn Signal Switch Circuit

Circuit diagnosis · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

The combination meter receives turn signal switch information and controls the turn signal lights.

WIRING DIAGRAM

E289821E01
E289821E02

INSPECTION PROCEDURE


1. READ VALUE USING GTS (TURN SIGNAL SWITCH)
  1. Using the GTS, read the Data List (Click here).

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Turn Signal Switch (Right)
    Turn signal switch (right turn position) signal / ON or OFF
    ON: Turn signal switch in right turn position
    OFF: Turn signal switch not in right turn position
    -
    Turn Signal Switch (Left)
    Turn signal switch (left turn position) signal / ON or OFF
    ON: Turn signal switch in left turn position
    OFF: Turn signal switch not in left turn position
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)

2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
  1. Remove the headlight dimmer switch (Click here).

  1. Inspect the headlight dimmer switch (Click here).



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH - COMBINATION METER)
  1. Disconnect the H74 headlight dimmer switch connector.

  1. Disconnect the H20 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    H74-11 (TL) - H20-27 (EL)
    Always
    Below 1 Ω
    H74-12 (TR) - H20-26 (ER)
    H74-13 (CR) - H20-25 (SW)
    H74-15 (EL) - Body ground
    H74-11 (TL) - Body ground
    Always
    10 kΩ or higher
    H74-12 (TR) - Body ground
    H74-13 (CR) - Body ground
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    H74-19 (TL) - H20-27 (EL)
    Always
    Below 1 Ω
    H74-20 (TR) - H20-26 (ER)
    H74-18 (CR) - H20-25 (SW)
    H74-16 (EL) - Body ground
    H74-19 (TL) - Body ground
    Always
    10 kΩ or higher
    H74-20 (TR) - Body ground
    H74-18 (CR) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Turn Signal Switch Circuit (Oct 2014 – Dec 2014)Turn Signal Switch Circuit (Apr 2016 – Dec 2016) →