2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL FRONT CRANKSHAFT OIL SEAL
  1. Apply MP grease to the lip of a new crankshaft oil seal.

    NOTICE:
    1. Keep the lip free of foreign objects.
    2. Do not allow MP grease to contact the dust seal.

  1. A343929E01
    Using SST and a hammer, tap in the front crankshaft oil seal.
    SST
    09214-76011  
    Text in Illustration 
    *1
    Front Crankshaft Oil Seal
    *2
    Timing Chain Cover Assembly
    *a
    0 to 1.5 mm (0 to 0.0591 in.)

    NOTICE:
    1. The acceptable depth from the top of the timing chain cover assembly is 0 to 1.5 mm (0 to 0.0591 in.)
    2. Keep the lip free from foreign matter.
    3. Do not tap the front crankshaft oil seal at an angle.
    4. Make sure that the front crankshaft oil seal is properly installed.


2. INSTALL CRANKSHAFT PULLEY
  1. Align the keyway of the crankshaft pulley with the key located on the crankshaft, and then slide the crankshaft pulley into place to install it.

  1. A343926E01
    Using SST, install a new pulley bolt.
    SST
    09213-58014   (91551-80840)
    09330-00021  

    Torque:
    365 N*m{ 3722 kgf*cm , 269 ft.*lbf }


3. INSTALL CRANKSHAFT PULLEY COVER
  1. Install the crankshaft pulley cover to the crankshaft pulley with the 4 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }


4. INSTALL FAN AND GENERATOR V BELT
(Click here)
← REMOVAL (from Jan 2017)COMPONENTS (from Jan 2017) →