2014-2019 Hiace · Service Manual TRANSMISSION

P2769/64 Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)

Diagnostic trouble codes · Vehicles built from Oct 2014

Also covers:

DESCRIPTION

The shift solenoid valve SL is turned "ON" and "OFF" by signals from the TCM in order to control the hydraulic pressure operation, the lock-up relay valve, which then the controls operation of the lock-up clutch.
DTC No.
DTC Detection Condition
Trouble Area
P2769/64
TCM detects short in solenoid valve SL circuit when solenoid valve SL is operated.
(1KD-FTV: 2-trip detection logic)
(2KD-FTV: 1-trip detection logic)
  1. Short in shift solenoid valve SL circuit
  2. Shift solenoid valve SL
  3. TCM
P2770/64
TCM detects open in solenoid valve SL circuit when solenoid valve SL is not operated.
(1KD-FTV: 2-trip detection logic)
(2KD-FTV: 1-trip detection logic)
  1. Open in shift solenoid valve SL circuit
  2. Shift solenoid valve SL
  3. TCM

MONITOR DESCRIPTION

Based on the signals from the throttle position sensor, mass air flow meter and the crankshaft position sensor, the TCM sends a signal to the SL Solenoid Valve to regulate the hydraulic pressure and provide smoother gearshifts. The shift-solenoid valve SL responds to commands from the TCM. The valve controls the lock-up relay valve to perform the torque-converter lock-up function. If the TCM detects an open or short circuit for shift-solenoid SL, it will illuminate the MIL.

WIRING DIAGRAM

C109045E04

INSPECTION PROCEDURE


1. INSPECT TRANSMISSION WIRE (SL)

  1. C113864E05
    Disconnect the transmission wire connector from the transmission.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    20°C (68°F)
    7 - Body ground
    11 to 15 Ω



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - TCM)

  1. F045523E32
    Connect the transmission wire connector to the transmission.

  1. Disconnect the connector from the TCM.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    20°C (68°F)
    O1-16 (SL) - Body ground
    11 to 15 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM

3. INSPECT SHIFT SOLENOID VALVE SL

  1. G038834E02
    Remove the shift solenoid valve SL.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    20°C (68°F)
    Solenoid Connector (SL) - Solenoid Body (SL)
    11 to 15 Ω

  1. Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

    OK:
    The solenoid makes an operating sound.



NG
REPLACE SHIFT SOLENOID VALVE SL
OK

REPAIR OR REPLACE TRANSMISSION WIRE


← P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) (from Jan 2017)U0100/A2 Lost Communication with ECM/PCM "A" (Oct 2014 – Dec 2016) →