U0100/A2 Lost Communication with ECM/PCM "A"
Diagnostic trouble codes · Vehicles built Oct 2014 – Dec 2016
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
DESCRIPTION
The TCM communicates with the ECM through the Controller Area Network (CAN). If there is a problem in this communication, the TCM sets the DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0100/A2 |
When TCM cannot receive communication signals from ECM. (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (TCM - ECM) |
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance.
- Standard Resistance:
for 1KD-FTV w/ DPF Tester Connection
Condition
Specified Condition
O3-21 (CAN+) - D99-40 (CAN+)
Always
Below 1 Ω
O3-20 (CAN-) - D99-63 (CAN-)
Always
Below 1 Ω
O3-21 (CAN+) or D99-40 (CAN+) - Body ground
Always
10 kΩ or higher
O3-20 (CAN-) or D99-63 (CAN-) - Body ground
Always
10 kΩ or higher
for 1KD-FTV w/o DPF Tester Connection
Condition
Specified Condition
O3-21 (CAN+) - D98-40 (CAN+)
Always
Below 1 Ω
O3-20 (CAN-) - D98-63 (CAN-)
Always
Below 1 Ω
O3-21 (CAN+) or D98-40 (CAN+) - Body ground
Always
10 kΩ or higher
O3-20 (CAN-) or D98-63 (CAN-) - Body ground
Always
10 kΩ or higher
for 2KD-FTV Tester Connection
Condition
Specified Condition
O3-21 (CAN+) - B88-4 (CAN+)
Always
Below 1 Ω
O3-20 (CAN-) - B88-5 (CAN-)
Always
Below 1 Ω
O3-21 (CAN+) or B88-4 (CAN+) - Body ground
Always
10 kΩ or higher
O3-20 (CAN-) or B88-5 (CAN-) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. REPLACE TCM |
Replace the TCM.
- NOTICE:
- Replace the TCM with a TCM from a normally functioning vehicle of the same model.
| NEXT | |
| 3. CHECK DTC OUTPUT (DTC U0100/A2) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Clear the DTC (Click here).
Turn the ignition switch off and turn the tester off.
Start the engine and turn on the tester.
Select the item: "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
- Result:
Display (DTC output)
Proceed to
U0100/A2
A
No DTC
B
- HINT:
- When not using the intelligent tester, refer to DTC CHECK / CLEAR (Click here).
|
|
||||
| A | ||
| ||
