REMOVAL
Removal / installation · Vehicles built from Jan 2017
- NOTICE:
- When using a vise, do not overtighten it.
- When installing the parts indicated by arrows, coat them with power steering fluid (Click here).
- When using a vise, do not overtighten it.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. DRAIN POWER STEERING FLUID |
| 3. REMOVE FAN AND GENERATOR V BELT |
While turning the V-ribbed belt tensioner assembly clockwise, align the service holes of the V-ribbed belt tensioner assembly, and then insert a pin with a diameter of 5.0 mm (0.197 in.) into the service holes to fix the V-ribbed belt tensioner assembly in place.

Text in Illustration *a
Service Hole
*b
Pin
Remove the fan and generator V belt.
| 4. REMOVE NO. 1 OIL RESERVOIR TO PUMP HOSE |
Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the vane pump assembly.

| 5. REMOVE PRESSURE FEED TUBE ASSEMBLY |
Remove the union bolt and pressure feed tube assembly from the vane pump assembly.

Remove the gasket from the pressure feed tube assembly.
| 6. REMOVE VANE PUMP ASSEMBLY |
Remove the 2 bolts and vane pump assembly.

