2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY

  1. G037688E02
    Check the output voltage.

    1. Apply battery voltage across terminals 1 (+B) and 2 (E2G).

      NOTICE:
      While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    2. Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG) and the negative (-) tester probe to terminal 2 (E2G).

    3. Blow air into the mass air flow meter, then check that the voltage fluctuates.
      If the voltage does not fluctuate, replace the mass air flow meter.

  1. G037689E02
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      4 (THA) - 5 (E2)
      12.5 to16.9 kΩ at -20°C (-4°F)
      4 (THA) - 5 (E2)
      2.19 to 2.67 kΩ at 20°C (68°F)
      4 (THA) - 5 (E2)
      0.50 to 0.68 kΩ at 60°C (140°F)

      If the result is not as specified, replace the mass air flow meter.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →