2014-2019 Hiace · Service Manual BODY

Power Window Master Switch Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

This circuit supplies power to operate the power window master switch.

WIRING DIAGRAM

B111214E03

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (POWER WINDOW MASTER SWITCH - BATTERY AND BODY GROUND)

  1. B063771E03
    Disconnect the K5 (L5) connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    L5-6 (B) - Body ground
    Always
    10 to 14 V
    L5-7 (BW) - Body ground
    Ignition switch ON
    10 to 14 V
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    K5-6 (B) - Body ground
    Always
    10 to 14 V
    K5-7 (BW) - Body ground
    Ignition switch ON
    10 to 14 V


    Standard resistance:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    L5-1 (GND) - Body ground
    Always
    Below 1 Ω
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    K5-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION IN PROBLEM SYMPTOMS TABLE


← TERMINALS OF ECU (from Oct 2014)Front Passenger Side Power Window Switch Power Source Circuit (from Oct 2014) →