INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT VACUUM SWITCHING VALVE ASSEMBLY |
Measure the resistance of the VSV.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
37 to 44 Ω
1 - Body Ground
2 - Body Ground
Always
10 kΩ or higher
Check operation of the VSV.

Attach a vacuum pump to port E and check that vacuum does not flow from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
Apply battery voltage across terminals 1 and 2.

Attach a vacuum pump to port E and check that vacuum flows from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
