2014-2019 Hiace · Service Manual RESTRAINTS

Driver Side Seat Belt Warning Light does not Operate

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

DESCRIPTION

When the ignition switch is turned to ON, the combination meter assembly monitors the state of the front seat inner belt assembly LH*1 (or RH*2). The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter according to the parking brake condition, shift lever position, vehicle speed and state of the front seat inner belt assembly LH*1 (or RH*2).
  1. *1: for LHD
  2. *2: for RHD

HINT:
The seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.


WIRING DIAGRAM

B343431E01

INSPECTION PROCEDURE


1. READ VALUE USING GTS (DRIVER SIDE BUCKLE SW)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Read the Data List according to the display on the GTS.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Side Seatbelt Buckle Switch
    Driver side seat belt buckle signal / ON or OFF
    ON: Driver side seat belt unfastened
    OFF: Driver side seat belt fastened
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. Disconnect the H20 combination meter assembly connector.

  1. Disconnect the R2*1 or B11*2 front seat inner belt assembly connector.

    1. *1: for LHD
    2. *2: for RHD

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    H20-10 (L) - R2-2
    Always
    Below 1 Ω
    H20-10 (L) - Body ground
    Always
    10 kΩ or higher
    R2-1 - Body ground
    Always
    Below 1 Ω
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    H20-10 (L) - B11-2
    Always
    Below 1 Ω
    H20-10 (L) - Body ground
    Always
    10 kΩ or higher
    B11-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)
  1. Remove the front seat inner belt assembly (driver side) (Click here).

  1. Inspect the front seat inner belt assembly (driver side) (Click here).



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← ON-VEHICLE INSPECTION (from Oct 2014)Driver Side Seat Belt Warning Light does not Operate (Jan 2015 – Dec 2016) →