Driver Side Seat Belt Warning Light does not Operate
Circuit diagnosis · Vehicles built Jan 2015 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
When the ignition switch is turned to ON, the combination meter assembly monitors the state of the front seat inner belt assembly LH*1 (or RH*2). The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter according to the parking brake condition, shift lever position, vehicle speed and state of the front seat inner belt assembly LH*1 (or RH*2).- *1: for LHD
- *2: for RHD
- HINT:
- The seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING GTS (DRIVER SIDE BUCKLE SW) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
Combination Meter Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Driver Side Seatbelt Buckle Switch
Driver side seat belt buckle signal / ON or OFF
ON: Driver side seat belt unfastened
OFF: Driver side seat belt fastened
-
- OK:
- The display is as specified in the normal condition column.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND) |
Disconnect the H20 combination meter assembly connector.
Disconnect the R2*1 or B11*2 front seat inner belt assembly connector.
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- for LHD:
Tester Connection
Condition
Specified Condition
H20-10 (L) - R2-2
Always
Below 1 Ω
H20-10 (L) - Body ground
Always
10 kΩ or higher
R2-1 - Body ground
Always
Below 1 Ω
- for RHD:
Tester Connection
Condition
Specified Condition
H20-10 (L) - B11-2
Always
Below 1 Ω
H20-10 (L) - Body ground
Always
10 kΩ or higher
B11-1 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) |
Remove the front seat inner belt assembly (driver side) (Click here).
Inspect the front seat inner belt assembly (driver side) (Click here).
|
|
||||
| OK | ||
| ||
