ABS Warning Light does not Come ON
Circuit diagnosis · Vehicles built Jan 2015 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (Click here).INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM
|
 |
Check if CAN communication system DTCs are output (Click here).
- Result:
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. PERFORM ACTIVE TEST USING GTS (ABS WARNING LIGHT) |
 |
Connect the GTS to the DLC3.
Turn the ignition switch off.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
ABS/VSC/TRC
Tester Display
|
Test Part
|
Control Range
|
Diagnostic Note
|
ABS Warning Light
|
ABS warning light
|
Warning light OFF/ON
|
Observe combination meter assembly Vehicle condition: Vehicle stopped
|
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
ABS/VSC/TRC
Tester Display
|
Measurement Item/Range
|
Normal Condition
|
Diagnostic Note
|
ABS Warning Light
|
ABS warning light / ON or OFF
|
ON: Warning light on OFF: Warning light off
|
-
|
- Result:
Result
|
Proceed to
|
ABS warning light in the Data List turns ON/OFF using the Active Test
|
A
|
ABS warning light in the Data List does not change using the Active Test
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 3. INSPECT COMBINATION METER ASSEMBLY |
 |
Turn the ignition switch off.
Perform Active Test of the combination meter assembly using the GTS (Click here).
Check the combination meter assembly.
- OK:
- The ABS warning light turns on or off in accordance with the GTS.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|