2014-2019 Hiace · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE


1. INSPECT ABS WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the ABS warning light comes on.

    OK:
    ABS warning light comes on.

    HINT:
    If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step (Click here).



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY

2. CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND COMBINATION METER ASSEMBLY)

  1. C111162E07
    Turn the ignition switch off.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-13 (WA) - H20-39 (S)
    Below 1 Ω
    B19-13 (WA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter (Click here).

    HINT:
    If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END


← ABS Warning Light Remains ON (from Jan 2017)ABS Warning Light does not Come ON (Jan 2015 – Dec 2016) →